Hi All,
I just finished setting up my system using OS X.
On the surface, all looks good. However, when I hit “start”, the system counts
down 3,2,1… GO!
However, my magnets aren’t getting the dials to move, or update anything on the screen.
I’ve played with this for hours now, and haven’t made any progress. Anyone have any ideas? Thanks.
Hi All,
I just finished setting up my system using OS X.
On the surface, all looks good. However, when I hit “start”, the system counts
down 3,2,1… GO!
However, my magnets aren’t getting the dials to move, or update anything on the screen.
I’ve played with this for hours now, and haven’t made any progress. Anyone have any ideas? Thanks.
Scott have you setup up Serproxy yet? Post your cfg file so we can take a look.
Below is my .cfg file.
Thanks so much.
# Config file for serproxy
# See serproxy’s README file for documentation
# Transform newlines coming from the serial port into nils
# true (e.g. if using Flash) or false
newlines_to_nils=true
# Comm ports used
comm_ports=1,2,3,4
# Default settings
comm_baud=19200
comm_databits=8
comm_stopbits=1
comm_parity=none
# Idle time out in seconds
timeout=3000
# Port 1 settings (ttyS0)
net_port1=5331
# Port 2 settings (ttyS1)
net_port2=5332
# Port 3 settings (ttyS2)
net_port3=5333
# Port 4 settings (ttyS3)
net_port4=5334
serial_device1=/dev/cu.usbserial-A7005NV3